Best Way To Remove Broken Headphone Jack From Ipad

Use a new dry Q-tip pull most of the cotton off and insert it gently in the jack.

Best way to remove broken headphone jack from ipad. Insert the toothpick or paperclip into the socket until it touches the headphone jack. September 4 2008 Hi So I plugged in a 35mm jack plug into my iPhone 3G to test an audio system and on removing it the end broke off and is now stuck in the iPhone headphone socket. Hold in place for a few seconds so that it can harden.

Wait for it to cool for a few minutes. If the tiny post has a corresponding socket on the headphone jack where it separated just put the superglue inside the hole. To clean a headphone jack start by removing the cotton from the end of a cotton swab until its the width of the swabs middle portion.

3 Slide the END of the ink cartridge down onto the metal jack. A tiny tiny amountjust enough to get the end of the post and maybe spill over to the sides a smidge. After that slowly push the bare end of the swab into the jack and spin it to brush off the sides of the jack and dislodge any debris.

5 Once you have it all the way down pull up slowly and the broken jack should slide out. Try using a toothpick. Dry off with a dry part of the thin microfiber cloth.

2 Remove the inner piece with the ink in it ink cartridge. Method 1 1 Try using a Paper-mate or BIC pen. 4 Push it down as far as it will go to try and get the ink cartridge plastic around the broken jack.

If it doesnt remove the staw slowly with the jack facing the floor and then take a pair of tweezers and grab the part that has already slipped out and pull it out carefullyIts cheap and fast and worked for. GripperX Headphone Plug Extraction Tool with Key Ring and Cleaning Brush - Remove Broken Headphone Plug from Headphone Jack of Mobile Devices 33 out of 5 stars 140 1499 14. This will absorb any moisture that was left behind.