Best Way To Solder Small Wires

When melting the solder to the wires try not to touch the iron with the solder.

Best way to solder small wires. Copper even that thin still melts at a much higher temperature than the 300C or so solder does. X Research source A couple examples of little projects you can work on are soldering a small LED light or connecting wires to a mini circuit board. Install the shrink wrap first solder the wires then slide the wrap to cover the solder shrink the wrap with a flame careful the wrap can shrink too much and split open then you will need to start over.

Find a small piece of sturdier wire 20AWG might be good. Glue or tape it to the board with tape under if needed for insulation so the end goes past where it will connect. Put a bead-sized amount of rosin flux on your finger and rub it over the exposed wires.

Soldering is something that you really only improve at by doing so the best way to get better is to just do as much soldering as you can. Meets The EU RoHS Directive 201165EU Claim. Wrap a bit of the 30AWG wire in a spiral around the 20AWG wire and solder.

Offer a Variety Of Connectors. Before touching the soldering tip to the wires tin the tip by melting a small amount of solder on it. This will help conduct heat to the wire.

I will be using a power probe butane soldering gun. So now you know what tools to use for soldering im going to show you the five simple steps to solder. Solder with shrink wrap.

This is often used in aerospace but is the worst for solder. Meets The EU RoHS Directive 201165EU Claim. Try to coat the wires as evenly as possible so theres a thin layer of flux on them.