How Do You Solder Two Wires Together

Let the solder melt and flow over the wires.

How do you solder two wires together. Mechanical connectors which physically clamp the wires together or to a common conductor are the easiest but they take up more room and particular kinds are prone to failure. Obviously these should not be connected to a power source at the time. You might even tack the wires together with some heat to hold them in position before binding the joint and re-soldering.

Apply Soldering To Copper Wire After doing all this preparation you can now apply the soldering to the copper wire. Heat the copper and apply solder to the side opposite the heating implement. Hold the wires together in one hand and use your free hand to twist the free ends.

You only have two hands which will be used to hold the solder and the iron. Use nothing but 60-40 rosin-core solder intended for electrical wiring. A simple solution if you dont have a soldering iron handy is to use heat shrink solder sleeves.

This simultaneously melts the solder and shrinks the sleeve. Just get wheel collars that are the appropriate size. Once cooled and hardened the resulting soldered bond or joint is considered to be permanent.

To do this follow these steps in order. I will be using a power probe butane soldering gun. Pass one wire in each end so that they cross over in the solder ring then simply apply a heat gun.

Step 7 Remove the wires from the vise when they have cooled and using the needle-nose pliers twist the two soldered wires together to form an initial bond. Twist and fold 2. There are three common techniques to solder wires together.