How To Get Good At Stick Welding

This arc-welding circuit has a voltage output of up to 79 volts which is enough to shock.

How to get good at stick welding. It is very efficient for welding most joints and alloys. You may be able to set the welder right near your fab table and get to work. How you connect your equipment will also determine the choice between the positive and the negative electrode.

When you stick weld you must strike the arc like a match using the stick which can be hard to do. To get a good connection. Usually there are two connectors on your welder one marked with and one marked with -.

Weld splatter is not a good look mostly you will get weld splatter during arc or stick welding and even with the best MIG welders. Connect the work clamp as close as possible to the area you wish to weld. Stick welding aluminum works best on thicker materials.

Stick welding allows you to create a secure and effective bond even on dirty and rusty metals. Also make sure to remove any rust moisture oil or any kind of impurities from the surface of the metal before welding. You will connect your stick holder and ground clamp there.

Use a wire brush or grinder to remove dirt grime or rust from the area to be welded. Ignoring these steps hurt your chances to make a good weld the first time. Flux is simply a chemical agent that burns down and creates a shielding gas.

For most of the stick welding applications you need to connect your electrode lead to the positive terminal and ground lead to the negative DCEP connection. It is possible to have a slight shock on rare occasions but Its even rarer to receive a harmful or lethal shock. Making your stick welder settings for DCEP or DCEN is important.