How To Make A Simple Homemade Soldering Iron

Use a coathanger wire cutter and ingenuity to make a soldering iron stand.

How to make a simple homemade soldering iron. Simple DIY homemade soldering station MK936 Circuit. I flipped the switch off and it cooled quickly. Create a simple soldering iron at home.

With just a USB cable an adapter a heat treatment fiberglass sleeving a chump of wood a 01mm nichrome wire and a 25mm wire copper you can make this amazing project in no time. It could come in handy as a quick replacement for a lost stand or you can go crazy and make a really pretty one to. I just connected the charging leads to a home made hand piece applied it to my brass pieces flipped the switch and applied the solder.

In about 4cm roll the insulator over the copper tip. This project demonstrates a simple soldering iron stand that you can build using a piece of thick wire and some basic tools. DIY Soldering Iron Stand.

Slightly bend 1 strip of metal. Attach one end of the heater nichrome wire about 0305 mm diameter near the sharp end 3 and start winding it over the insulation to make the heater resistor 4. Normally for soldering iron 2 ampere to 4 ampere current is enough for this.

A wooden block is needed for the handle and copper wires must be insulated. Hair Dryer I had one at home Bare Copper wire 8 Gauge 18 Gauge RedBlack Connector Wires. It heated almost instantly melted the solder.

For small amounts of work you can make a simple soldering iron. To start cut off a 2cm wire copper and attach it to the heat treatment fiberglass sleeving. There are a lot of different soldering stations on the Internet but everyone has their own characteristics.