How To Make Solder Stick To Tip

Press the blob of solder into the metal to be soldered.

How to make solder stick to tip. Add Tip Ask Question Comment Download Step 4. Holding the solder in one hand and the iron in the other briefly touch the solder to both sides of the tip. It takes practice and then apply solder form the opposite side of where the tip is making contact.

First place its point over the hole On the Solder Side and while pushing down heat up the solder a bit on one side of the needle. The bursh-in-bottle type is perfect. The selected temperature for a soldering iron tip affects tip life by accelerating the oxidation of the tip and the reaction of the solder and flux with the iron plating of the tip.

After the points are dried you will need to solder. The easiest way is to push the end of the solder through the gap between the tip of the iron and the wire. Tip temperature also causes physical changes to the tip through the natural thermal expansion and contraction the metal undergoes during normal use.

Use liquid flux on the bare wire terminal. Clean properly the soldering area and all components as well. Remove the iron and let the PCB cool for a few seconds and than pull out the needle.

I suspect chrome doesnt accepts solder well. Touch the seam so that the ball sticks to the solder seam Continue along making the balls as close or far apart as you like. Melt a small dot of solder over the tip in a thin coat.

Good luck wetting stainless too. Now simply melt a small ball of 6337 solder over one of the seams until it forms a little ball. Hold the iron tip at a 45-degree angle to the glass.