How To Make Solder Tips

After soldering check the solder joints carefully.

How to make solder tips. Just scrape the tip across the sponge gently then rotate the iron and scrape gently across the sponge again. If you tin the tip before you put down the soldering iron for the day it is said that the tip should last longer. Heat the joint with your soldering iron and place the tip of the solder sucker over the hot solder.

When you think about it the time to if youve already been soldering let the iron cool change the tip heat it back up remove the resistor let it cool again change the tip back heat it back up again then back to soldering. Do not keep the soldering iron tip more than 3 seconds on the soldering joint when soldering CMOS components. Step 5 Trim to fit.

We clean the soldering tip and we place the components one by one so I will solder this IC socket which has 16 pins. The heat of soldering dramatically accelerates this process. Once youve chosen the right solder for the job youre ready to complete the process.

It is better to keep a small bottle of alcohol and some q-tips and cotton swabs handy to clean the area afterwards. When done I removed tape cleaned flux off and trimmed wire to length. A cold solder joint happens when the hot solder hits a cold wire hardening it.

Touch the tip of the soldering iron to the wires and keep it there. Its important to make the gap in the solder joint as small as. The following information will help you to better understand the what of soldering and improve your ability to achieve clean problem-free solder bonds.

Ad Wholesale Mobile Accessories Parts Electronics With 12 years Experienced Supplier. Press the release button to suck up the liquid solder. If necessary use a brass soldering iron cleaner or damp sponge to clean the tip.