How To Make Soldering Iron Tip
When using the iron keep a little solder on the tip when the iron is in the stand.
How to make soldering iron tip. The power regulator for a soldering iron provides its change in the necessary mode. Be sure that the soldering iron tip is held in the horizontal to the sensor with minimal movement to maximize physical contact between the middle of the working surface of the tip and the sensor. To last long treat it gently.
Insert the Tip in Good Quality Tip Tinner. If so you can do it with a normal soldering iron. Avoid excessive wiping on a wet sponge as this can cause temperature fluctuations which expand and contract the metal and stress the tip.
Maintain your soldering iron for long life by keeping the tip clean. How to Tin or Re-Tin Soldering Iron Tip. Wipe the iron on a damp sponge to remove the excess.
Wipe the tip of the soldering iron on a damp wet sponge to clean it. Melt some good quality of solder wire on the Tip. Switch on the Soldering Station or the Iron and Make sure it is Hot Enough.
Apply lots of solder to one side of the resistor then quickly melt the other side and flick it off. Wait a few seconds to let the tip heat up again before proceeding to step 4. In this video I show you how to tin a soldering iron tip old or new and other care tips.
The tip of the soldering iron is made of a copper core plated with iron. The power regulator on the triac. Tools vise hacksaw small drill press file sandpaper steel wool etc Note.