How To Make Your Own Soldering Wire

More accurate and improve your working speed.

How to make your own soldering wire. Wire cap connectors provide their own insulation though you need to make sure that there isnt any bare wire visible. Using jump rings is probably the easiest way. Connect the switch to the red wire on one side.

This can be done with electrical tape or insulation wraps as well as shrink-to-fit insulation sleeves that you fit over the join and then apply heat to shrink. Preassemble your cable parts and check for size before you solder. If you want the kids to be able to solder the wire it will be good for you to tin it first as the flux fumes are also nastier than those of conventionally fluxed solder.

Stretch a piece of 38 heatshrink to fit over the external header shrink it and youre all done. The connection will be on the top part of the unit. Lightly tug on your solder job to make sure no wires come loose.

Cut off any bullshit on the end of the wire. Clean and tin the tip of the iron with a dab of solder lay the center conductor on the pad of solder in the solder cup and press the tip into the wire and cup. Ad Quality Solder Wire Drawing Machine.

Finally add a piece of heatshrink to the bottom and youre all done. Be careful not to fray the cut end of the cable. This is an investment that will make your soldering.

Make a slit starting 2 inches from the end of the wire all the way to the end. Many people apply electrical tape over the caps just to make sure. On the other side connect the red wire to the nichrome wire at the base.