How To Prepare A Soldering Iron Tip

Apply a little solder to the irons tip and place the iron on top of the wire and lightly press down towards the rail.

How to prepare a soldering iron tip. Turn on the soldering iron and set temperature above the melting point of your solder. Once every item has been tinned place the wire end which has been bent to a small L shape up to the solder on the rail. Operate at the lowest possible temperature 800F 427C or lower.

Tinning will also help to protect the tip and reduce wear. Soak the sponge using the water squeeze it out a little then use it to clean the tip of the soldering iron. I havent used the hard-way tip yet Then I dipped the tip halfway into flux wrapped it up in high-tin solder.

When it comes to the sponge cleaning method be sure to use de-ionized water to prevent contamination as well as a sponge specially-rated for soldering so it is sure to withstand the high temperature. Fit the tip back to the heater assembly once. To use the Tip tinnercleaner heat the soldering iron.

It also minimizes exposure beyond the surface of the tip. Plug in the iron and switch it on. If you are taking good care of your soldering iron it would last longer than usual.

To maintain the performance of any soldering iron tip a simple maintenance procedure is recommended. Well when the iron soldering warms up the iron plating which is the working surface would start oxidizing due to the temperature. Before you can start soldering you need to prep your soldering iron by tinning the tip with solder.

Begin by making sure the tip is attached to the iron and screwed tightly in place. Use set screws to re-assemble the iron. Wipe the iron on a damp sponge to remove the excess.