How To Remove A Broken Headphone Piece From An Ipad

It should go in about the same length of a headphone plug.

How to remove a broken headphone piece from an ipad. If pushing it by hand does not work try to very lightly and slowly tap it in. Hold the pen by its nib and pull the inner ink tube out. Dont push it in too far as it could bend the tip.

Another option is to use a dab of super glue to reconnect the two broken pieces of the headphone plug. Now wait a few seconds or minutes depending on how long the glue takes to really stick. My hint to remove the piece.

Now half of my headphone jack is stuck in my ipad and I cant get it out. If that doesnt work then take a paperclip straighten the end of it. Do not screw in excessively or risk pulling the entire receptacle out of iPad.

If you are using the device that has the broken piece in it simply turn on the captions by clickin. Grab the screw with pliers and pull. This method works for me very well.

Wait 2-3 minutes or until melted plastic has thoroughly cooled. Put AirPods in their case and close the lid. Than apply superglue to the front.

To clean a headphone jack start by removing the cotton from the end of a cotton swab until its the width of the swabs middle portion. JUST the very end of it. Not sure if it will work but you can try.