How To Restore A Soldering Iron Tip

Dip the tip into the tinner making sure that the entire oxidized surface is in contact with the re-tinning product.

How to restore a soldering iron tip. If some of the oxides are just sticking really well you could try to mildly abrade them on a brass sponge copper braid or similar but you cant be too hard or you will damage the iron plating good tips are typically copper core plated with iron then chromium everywhere but the. Iron again which means adding a fair amount of solder and letting it. Set the solderingdesoldering station to a temperature of 300C approximately 575F Add a flux cored wire solder that will be used in your applications or use the HAKKO FS-100 Tip Polish.

ANd of course if you dont tin the tip in the first place again letting. Unroll a portion of solder then roll the hot tip of the iron from the end of the solder until it does one complete turn on the solder. Push the soldering iron tip into the chemical cleaner until the entire rusted area is submerged.

If it doesnt you need to remove all solder and grind the. It took a lot of effort with tip tinnercleaning compound to make the solder wet the tip again. Try not to leave the iron sitting hot on the bench while not in use.

This will restore the soldering iron to its normal functionality. In the case of soldering iron tip requires most of your attention and care. In this case soldering iron coil wire will be turned off if it has reached a certain temperature.

If the tip gets really bad it can often be restored with a chemical tip tinner. A soldering iron functions by heating up an element that transfers heat to the tip. You can repair a malfunctioning soldering iron by replacing the heating element.

In some expensive soldering iron there is a thermal shutdown feature also available. The solder melts and should stick at the tip. Leave it there until the paste melts around the tip.