How To Solder 3 Wires
Make sure your soldering iron is fully heated and touch the tip to the end of one of the wires.
How to solder 3 wires. Then practice soldering two wires together after youve tinned them. Cover With Heat Shrink. Remove the soldering iron and allow the soldered connection to cool and harden for a few seconds.
The first step is you need to strip your wires. Move the iron to the opposite bottom side of the connection and repeat the same technique. Tap the end of the 6337 solder on top of the wire splice so the solder melts down into the wires.
Set the iron to the solders temperature range. The challenge is holding the wires in place long enough for the solder to cure. Its not too difficult.
This process should melt the solder and coat both wires evenly. And allow the solder to melt. Run the solder over the entire splice so it can melt and travel into the gaps between the wires.
Make a solid mechanical connection. The process for soldering 3 wires together is the same as splicing 2 4 or even 10 of them. It helps to start the heat transfer by dabbing the solder at the point where the iron and wires meet then move the solder to the top.
I need some help as in how to solder it on to a 35mm jack 4 pole. Place the soldering iron underneath the wires and apply the solder from the top. 60tinpine resin and 40lead.