How To Solder Wires For Beginners

Unspool a bit of solder and touch it right to the knotty wire connection.

How to solder wires for beginners. Keep the soldering iron on the bottom of the wire to continue heating it. Tin the wire by heating the wire with the soldering iron and touching the solder to the wire and not the irons tip. Hold the two tinned wires on top of each other and touch the soldering iron to both wires.

Remove the insulation from both ends of your wires that youre soldering together. Alternatively a mechanical vacuum known as a solder sucker can be used. You can do this tinning part in two ways.

Run the solder over the entire splice so it can melt and travel into the gaps between the wires. To do this put the end of the stripped wire in rosin and heat it with a soldering iron - thereby bathing the wire in rosin. Hold the two tinned wires on top of each other and touch the soldering iron to both wires.

Melt a small drop of solder on to the surface where the wire will be connected. If you want to join two wires with solder the first thing you should do is to tin the two wires. The sucker is placed over the joint and a button pressed to suck the molten solder.

The copper on the board needs to be well copper coloured or shiny silver from being tinned and so do the component leads. Heat up your soldering iron and once fully heated touch the tip to one end of the wire. Tips for successful and safe soldering for beginners.

Remove solder iron and allow 10 seconds for it to cool down. Continue melting the solder until theres a thin layer of solder covering all of the exposed wire. SMT Solder Wire is done as follows.