How To Use A Router Table As A Planer

Feed the material from right to left.

How to use a router table as a planer. If you find your router pulling away from the straight edge your direction of feed is backwards. Remember the bit rotation from the top is clockwise so with your straight edge on the left make a push cut and the rotation will hold the router tight to the fence photo 13 - above. Diy router sled tutorial for the big make your router think it s a jointer easy and adjule diy router planer slab flattening mill woods.

Using A Router Table As Planer. The second part of the sled is a bridge that holds the router and rides on top of the sled box. Mount the screws with the heads raised slightly.

Mount your router base to the jig and install a mortising bit or a wide straight bit in your router. Masuzi January 29 2018 Uncategorized Leave a comment 74 Views. These screws will prevent the jig from moving side to side before the router bit cuts into the rails.

Transverse the work with the router sled resting one side on the established rail and the other on the new rail. Provide easy access to the mains and due power connection and check that the table power switch is operable to be able to activate and turn the tool off when needed. WITH THE ROUTER OFF move the jig around until it finds a high spot.

This bridge is also just a fancy box. Step 1. Turn on your router and run some scrap material across the table using the fence to guide and support the piece.

You can use an inverted table-mounted router to straighten narrow edges. Using a combo-square mark lines across the jig at the edges of the hole. It requires a straight bit and an offset fence.