How To Use A Soldering Heat Gun

Normally if I have several SMDs to do near each other I will do all of them at the same time.

How to use a soldering heat gun. Press the soldering gun onto one side of the wires to melt the flux. Heat Guns allow you to concentrate the heat onto a targeted area or surface also give you control using the on and off trigger. Heat Guns are a handheld tool that uses a stream of the hot air which is heated by a built-in element at temperatures between 100C and 550C.

Keep some water around for the sponge in your solder station. Through Hold Component Soldering on Circuit Boards. It delivers heat to the tip of the soldering gun.

Pressing on the syringe plunger forces the solder paste through a blunt needle which is often used to apply solder and flux directly to the PCB pads before placing the surface mount components. Solder pastes are made of tiny solder balls with flux and they are basically same as solder wires but sometimes use of solder. This was done only to de.

Tin foil for a heat shield for use with heat guns. Solder paste is also available in small jars from which the paste may be transferred to a syringe or applied directly to the PCB using a very small tool to dip in the paste and dab on the pads. Then fire the heat gun onto the solder paste holding the component with tweezers or another tool that wont catch fire until it becomes shiny.

Its similar to the holder of a gun which is relatively easy to handle. Then carefully removereposition the part you want to rework using tweezers by nudging or grabbing the part. Keep in mind that hot-air is well hot.

Use a heat gun to heat it up closing the cover and voila. Apply plumbing solder but do NOT play the torch across the solder. This time it is about how to use solder paste for your soldering job.