How To Keep Solder Tip Clean

Clean the tip and then tin the tip if you need to put it down and clean and tin once you come back.

How to keep solder tip clean. Melt some good quality of solder wire on the Tip. The best tip tinner is your solder--tips should always be coated with a small amount of solder. Then immediately re-tin the tip with rosin core solder.

A layer of fresh solder keeps the layer right next to the tip from oxidizing. When you are done for the day simply wipe clean as the iron is cooling and it will be ready to go the next time. To use the Tip tinnercleaner heat the soldering iron.

This is done by first ensuring the tip is clean and free of surface oxides. This step will coat the iron in a mixture of flux and solder. With the iron tip cold use a polishing bar.

Keep the tip clean Keeping a tip clean is. Once your iron is heated up for a job wipe it on a wet sponge to remove old solder and apply solder to the tip. If some of the oxides are just sticking really well you could try to mildly abrade them on a brass sponge copper braid or similar but you cant be too hard or you will damage the iron plating good tips are typically copper core plated with iron then chromium everywhere but the working area.

Use fluxes Spongeless and metal wool to remove small amounts of contaminants from your soldering iron tips during soldering circuit board or any other components. This should lead to a clean shiny tip ready for use. Switch on the Soldering Station or the Iron and Make sure it is Hot Enough.

Use pliers to keep the start of the solder at place. The fat from your fingers might contaminate the cleaned surface and the solder will drip off where you touched it. Copper is used because its an excellent heat conductor but if exposed to solder it will quickly dissolve into the solder.