How To Make A Soldering Iron Stand At Home

Learn about soldering irons soldering guns circuit boards and more from Jeff Koskulics in these Howcast videos.

How to make a soldering iron stand at home. You should do this by starting to heat the tip. The SP25NUS is a light-duty LED soldering iron for the hobbyist and DYIer. Touch the solder to the tip of the iron and make sure the solder flows evenly around the tip.

Make a 120 degree bend in the straight side pointed towards the middle of the circle. While most jewelry makers and welders probably purchase their soldering irons its actually possible to make your own soldering iron out of graphite pencil car battery and jumper cables. Touch the solder to the tip of the iron and make sure the solder flows evenly around the tip.

If you want them to remain firmly connected youll have to make use of a normal tape to cover them together. Place the tip of the soldering iron onto each of the pads so that the solder melts and makes good connections between the component and the board. Wait a few seconds to let the tip heat up again before proceeding to step 4.

Step 3 - Form the Resting Stand for the Iron Holder. - drill a hole of the same side into the broomhandle. Accommodates the standard cleaning sponge.

It Can Accommodate Hakkos 599B Tip Cleaner Too. Before you start using the tool clean the tip with a wet cleaning sponge and continue to clean it throughout the process. The kit also includes an iron stand soldering aid tool lead-free solder and spare MT2 and MT3 tips.

Begin taking a piece of the solder and placing it on the corner of your box frame applying heat from the soldering iron to fasten the corner. This method is for soldering chips. - slowly neatly wrap the wire into a coil a dozen times.