How To Make Hot Air Soldering Gun

For installing SMT devices it might work better to use a soldering iron rather than hot air.

How to make hot air soldering gun. Use hot air gun set at 350C to blow it at a distance. Welding some plastics - 330 to 400C. Also make sure the tips are steel.

The four stages are. But most Solder has lead in it so. Materials such as PVC film linoleum rubber are welded by filling the weld with an alloyed filler wire which is achieved by a stream of hot air.

Use a fine tip iron solder one pad first on the corner of the part if its not quite right re-heat and shift the part until it is correct. The rework station is controlled by using an 858D microcontroller. Saying the magic spell meltum meltum meltum move the nozzle back and forth until the solder begins to flow the solder should appear shiney and molten.

See these videos on selection and use of tip shapes by Hakko for examples of SMT soldering. This contains a 220V heating element a 24v fan a termocouple and a reed switch. How to use dot masks for wave soldering and conformal.

The bundle is melted by heating to 350. It can reach up to a maximum temperature of 500 o C. You can work on projects and get zooted all at once.

To add a single new component to the board first place some solder paste on the component. Ya DO NOT USE A DIRTY TIP. Check out the 2in1 878ad Bonus comes with hot air gun.