How To Make Soldering Iron Stand

Hold the soldering iron in one hand and solder in the other.

How to make soldering iron stand. Then pull the solder away. Make a 120 degree bend in the straight side pointed towards the middle of the circle. - since it is now locked onto the broomhandle get your metal-blade hacksaw and cut the wire exactly where it enters the hole.

Sold by Electronix Express and ships from Amazon Fulfillment. Give the epoxy ample time to cure before using your new soldering iron stand. The prepared spring is inserted into the jar and the structure is fastened with a bolt and nut.

The first thing to do is cut a piece of flat tin into a 6 x 4 rectangle Click here to add your own comments. The finished design is assembled by tightening the spring inserted into the box with a bolt washer and nut. I used the glue gun screw and tape to attach the Carbon filter sponge behind.

For its manufacture does not require much time as well as. - slowly neatly wrap the wire into a coil a dozen times. Slightly bend 1 strip of metal.

Make a second 60 degree bend in it directly above the center of the circle so that it forms a V that the soldering iron can sit in. Using tweezers place the component in its correct position and hold it there. The bottom screw is fixed safe and non-slip and it is stable.

Easy to use easy to clean easy to disassemble. Step 3 - Form the Resting Stand for the Iron Holder. Wait a few seconds to let the tip heat up again before proceeding to step 4.