How To Make Soldering Iron Wire At Home

Then connect two pieces of thin copper wires at the two ends of the wire insulations.

How to make soldering iron wire at home. Put back the switch on the soldering iron. Part 1 and part 2. At this point plug the usb cable into a computer or usb wall outlet and ensure you have a good working connection.

Make sure you follow the instructions on the specific iron for temperature settings and proper usage. Once the flux starts bubbling you can begin adding solder. Make sure you tin both well.

As shown in fig no. Now using a second working soldering iron solder the black wire to the negative coil and the red wire to the positive plate below the switch. A cold solder joint happens when the hot solder hits a cold wire hardening it.

Use a good conditioned soldering iron. Now tape that. The two irons are coupled together using a simple 3D printed part.

The tip of the soldering iron will be made by the thick copper wire. Reattach the case to cover the internal components. Cut a length of copper wire and bend it in half.

Adriajunyent-ferre took a pair of cheap 5 USB soldering irons and turned them into a nifty pair of SMD soldering tweezers. Hold the soldering iron against the bottom of the splice to heat the flux. Attach one end of the heater nichrome wire about 0305 mm diameter near the sharp end 3 and start winding it over the insulation to make the heater resistor 4.