How To Prepare Soldering Iron Tip

Then of course you need to tin the.

How to prepare soldering iron tip. It will only take one or two seconds to warm the components. Plug in the iron and switch it on. The hot solder on the irons tip will cause both the wires solder and the rails solder to melt into one.

Operating at temperatures exceeding 850F dramatically increases the formation of iron oxides which. At this point the solder will float freely around the component lead and the pad. Wipe the iron on a damp sponge to remove the excess.

In order to prep a new soldering iron you should first be aware of how to use it. This step will coat the iron in a mixture of flux and solder. When the iron is hot wipe both sides of the soldering tip on the sponge.

Once every item has been tinned place the wire end which has been bent to a small L shape up to the solder on the rail. Apply a little solder to the irons tip and place the iron on top of the wire and lightly press down towards the rail. Your goal is to remove old solder from the tip.

If not wait a bit more or add more water to the sponge if its too dry. Make sure you clean and tin the tip of the soldering iron to make the most of it. So when its heating up you must apply solder 60 tin 40 lead to the tip and this process is called tinning the tip.

Sit for a few minutes before wiping it clean. Do not keep the soldering iron tip more than 3 seconds on the soldering joint when soldering CMOS components. When you unbox a brand new soldering iron the first thing you need to do is tin the iron plating on the tip to help protect it from oxidation.