How To Clean Spray Foam Tips

Rub down the exposed clothing with a dry rag that you dont mind throwing out later and take off all the insulation that came into contact with the fabric.

How to clean spray foam tips. Ensure anything that came in contact with spray mix has been cleaned. Clean the gun basket and tip by spraying and removing uncured foam with Great Stuff foam cleaner. To clean the inside attach the gun cleaner like you would any other foam can.

Clean with solution. After spraying the cleaning process relies on three main things. A little acetone squirted on fresh foam will dissolve it instantly.

For more information on foam. If the foam has not yet fully hardened wipe off as much as possible with a cloth or paper towel. Never cut at a 90-degree angle as this will ruin your wall completely.

Blot the remaining foam with some acetone nail polish remover. If youve created an unintentional sticky mess clean it up with acetone. Another trick to help remove foam from your hands or skin.

Repeat the process as needed. The entire purpose of these tools is to remove residue and contaminants. Dedicating a little time daily and a block of time either weekly or bi-weekly can save you a lot of time and money in the long run by keeping your spray foam rig operating smoothly.

Next use acetone or nail polish remover to rub at the foam-covered skin. But first test it on a more discreet section of the wall to make sure it wont do any damage. Allow the dispensing gun to sit for several minutes.